Vacuum ultraviolet photochemistry of methane, silane and germane
文献情報
Phillip A. Cook, Michael N. R. Ashfold, Yun-Jung Jee, Kyung-Hoon Jung, Stephen Harich, Xueming Yang
The photochemistry of jet-cooled CH4, SiH4 and GeH4 molecules following excitation at the Lyman-α wavelength (121.6 nm) has been investigated by high resolution photofragment translational spectroscopy methods. Complementary ab initio calculations of selected portions of the potential energy surfaces for the various components of the 1T2 and 3T2 excited states arising from the 3sa1←1t2 electron promotion are presented in the case of CH4. The form of the H atom recoil velocity distribution arising in the 121.6 nm photolysis of CH4 is rationalised in terms of initial excitation to both the 21A′ and 11A″ excited states (Jahn–Teller components of the degenerate 1T2 state), followed by a range of decay mechanisms. CH4(21A′) molecules can decay adiabatically, ia sequential extension of first one, then a second, C–H bond with eventual formation of two H atoms and CH2(ã1A1) products, or after internal conversion (IC) to the ground state. The H + CH3() products resulting from the IC process display a recoil velocity distribution characterised by an anisotropy parameter β∽ + 2, implying that the fragmentation involves irreversible extension of the C–H bond along which the transition dipole points at the instant of photon absorption. Fragmentation of CH4(11A″) molecules to H + CH3() products proceeds ia intersystem crossing to the lowest 3A′ potential energy surface. The recoil anisotropy of these products (β∽ − 0.45) implies that this radiationless process also occurs on a timescale that is rapid compared to the parent rotational period. Both single H–C bond fission channels may yield CH3() products with such high levels of internal excitation that they are unstable with respect to further unimolecular decay; any H atoms that result from this secondary decay must contribute to the observed yield of slow H atoms with β∽0. All H atoms resulting from Lyman-α photolysis of both SiH4 and GeH4 have (low) kinetic energies and little or no recoil anisotropy, compatible with their being formed ia three body fragmentation to, primarily, H + H + SiH2/GeH2(1A1) products. Faster H atoms are evident in the total kinetic energy release (TKER) spectra obtained following 157.6 nm photoexcitation of SiH4, but the power dependence of this fast H atom signal implies that these arise as a result of a two photon process involving initial formation of SiH2 + H2 products and subsequent photolysis of the nascent silylene fragments.
関連文献
Facile construction of functionalized 4H-chromenevia tandem benzylation and cyclization
Jinmin Fan, Zhiyong Wang
DOI: 10.1039/B812046C
Encapsulated molecular catalysts in polysiloxane gels: ruthenium cluster-catalyzed isomerization of alkenes
Motonori Abe, Kazuyuki Kamo, Yusuke Kosako
DOI: 10.1039/B809937E
Synthesis and reactions of the first fluoroalkylated Ni(ii) N-confused porphyrins
Hua-Wei Jiang, Qing-Yun Chen, Ji-Chang Xiao, Yu-Cheng Gu
DOI: 10.1039/B811831K
Concomitant formation of two different solvates of a hexa-host from a binary mixture of solvents
Dinabandhu Das, Leonard J. Barbour
DOI: 10.1039/B813891E
99m-Technetium carbohydrate conjugates as potential agents in molecular imaging
Meryn L. Bowen, Chris Orvig
DOI: 10.1039/B809365B
4-(Pyridin-2-yl)thiazol-2-yl thioglycosides as bidentate ligands for oligosaccharide synthesisvia temporary deactivation
Papapida Pornsuriyasak, Nigam P. Rath, Alexei V. Demchenko
DOI: 10.1039/B810569C
A facile approach to fabricate functional 3D macroscopic silica microtube networks using N,N′-methylenediacrylamide organogel as template
Yu Xia, Yu Wang, Kai Chen, Liming Tang
DOI: 10.1039/B811412A
A facile strategy to control polymer topology by variation of controlled radical polymerization mechanisms
Wen-Ming Wan, Cai-Yuan Pan
DOI: 10.1039/B811618K
Deprotonative cadmation of functionalized aromatics
Jean-Martial L’Helgoual’ch, Floris Chevallier, Mitsuhiro Yonehara, Masanobu Uchiyama, Aïcha Derdour, Florence Mongin
DOI: 10.1039/B809543D
こちらもおすすめ
S-(甲硅烷基丙基)異硫酰氯を取り扱う際の実験室安全事項は何ですか?
取り扱う際にはPPE(防護具)が必要です。特に手袋と面マスクは必須です。ドラフトチャンバーを使用して漏洩処理を行い、温度は常温、湿度は乾燥状態、容器はガラス容器...
8-硝基-咪唑并[1,2-a]吡啶とは何ですか?
8-硝基-咪唑并[1,2-a]吡啶は、CAS番号52310-46-0の化合物で、8-位に硝基を有する咪唑並みの结构をもつ吡啶の化合物です。この化合物は、酸化還元...
4-ブロモ-5-メトキシピリジン-2-甲醇の代替品はありますか?
4-ブロモ-5-メトキシピリジン-2-甲醇の代替品には、類似構造を持つ化合物や機能性に等しい代替試薬があります。例えば、4-クロロ-5-メトキシピリジン-2-甲...
全氟-1,2-二甲基環己烷を含む廃棄物はどのように処理すべきですか?
全氟-1,2-二甲基環己烷(CAS番号:306-98-9)の廃棄物は、特別な処理が必要です。まず、廃棄物を密閉容器に収集し、適切な防漏容器に保管します。次に、専...
3-(溴甲基)苯乙酸の主な用途は何ですか?
3-(溴甲基)苯乙酸は主に研究用化学薬品として利用され、有機合成や医薬品の開発に用いられます。また、特定の化合物の合成中間体としても使用されることがあります。
5-イドキド-4-メチオキシ-6-メチルピリミジニン-2-アミンはどのように保存すればよいですか?
5-イドキド-4-メチオキシ-6-メチルピリミジニン-2-アミンは冷暗所で密栓の容器に保存し、直射日光を避けて保管することをお勧めします。温度は常温とし、湿気を...
1-(2-溴-6-甲氧基苯基)乙酮を取り扱う際の実験室安全事項は何ですか?
実験室では、1-(2- Bromo-6-methoxyphenyl)ethanoneを取り扱う際には、ゴーグルや面具、手袋などのPPEを使用することが推奨されま...
5-(4,4,5,5-テトラメチル-1,3,2-ダイオキサボラロール-2-イル)-1,3-ジヒドロ-2-ベンゾフランは安全ですか?
5-(4,4,5,5-テトラメチル-1,3,2-ダイオキサボラロール-2-イル)-1,3-ジヒドロ-2-ベンゾフランは一般に安全ですが、取扱いには注意が必要です...
4-溴萘-1-甲酸の代替品はありますか?
4-溴萘-1-甲酸は比較的稀な化合物ですが、類似物としては、4-クロロ-1-ナフホリック酸やその他のブロモ置換ナフホリック酸が挙げられます。ただし、これらの代替...
ε-白藜芦醇脱氢二聚体の代替品はありますか?
ε-白藜芦醇脱氢二聚体の代替品としては、ε-白藜芦醇、ポリフェノール類、フラボノイド類が挙げられます。これらは類似の化学構造と生物学的活性を持っています。ただし...
掲載誌
Physical Chemistry Chemical Physics

Physical Chemistry Chemical Physics (PCCP) is an international journal co-owned by 19 physical chemistry and physics societies from around the world. This journal publishes original, cutting-edge research in physical chemistry, chemical physics and biophysical chemistry. To be suitable for publication in PCCP, articles must include significant innovation and/or insight into physical chemistry; this is the most important criterion that reviewers and Editors will judge against when evaluating submissions. The journal has a broad scope and welcomes contributions spanning experiment, theory, computation and data science. Topical coverage includes spectroscopy, dynamics, kinetics, statistical mechanics, thermodynamics, electrochemistry, catalysis, surface science, quantum mechanics, quantum computing and machine learning. Interdisciplinary research areas such as polymers and soft matter, materials, nanoscience, energy, surfaces/interfaces, and biophysical chemistry are welcomed if they demonstrate significant innovation and/or insight into physical chemistry. Joined experimental/theoretical studies are particularly appreciated when complementary and based on up-to-date approaches.











![4-Penten-1-yl 2-[(2-furylmethyl)(1H-imidazol-1-ylcarbonyl)amino]butanoate structure 4-Penten-1-yl 2-[(2-furylmethyl)(1H-imidazol-1-ylcarbonyl)amino]butanoate structure](https://static.chemtradehub.com/structs/101/101903-30-4-ac34.webp)


