Understanding the loss mechanisms in high-performance solution-processed small molecule bulk heterojunction solar cells doped with a PFN impurity
文献情報
Ali Aghassi, Cormac D. Fay
Contamination of the active layer with an impurity could result in significant degradation in the performance of bulk heterojunction (BHJ) solar cells as a result of enhancing the loss of the charge carriers via a trap-assisted recombination. In this study, PFN as an impurity was intentionally introduced to a BHJ solar cell composed of a high-performance solution-processed small molecule (p-DTS(FBTTh2)2 as a donor and PC60BM as an acceptor. The power conversion efficiency (PCE) of PFN doped devices degrades owing to the reduction of short-circuit current (Jsc) and fill factor (FF). At a low concentration, PFN mostly reduces the generation of charge carriers, whereas doubling the PFN concentration conversely affects both generation and collection of charge carriers. Charge carrier dynamics of devices has also been probed using photovoltage decay, time-resolved charge extraction (TRCE) and photoinduced charge extraction by linearly increasing voltage (photo-CELIV) before and after incorporation of PFN. The results reveal that traps introduced by PFN reduce the decay of charge carriers via bimolecular recombination, leading to a higher charge carrier density and photovoltage at long times under an open-circuit potential (Voc). However, under short-circuit (Jsc) conditions, traps considerably impede the collection of charge carriers causing the appearance of an S-shaped current density–voltage curve.
関連文献
α-Diimine nickel complexes bearing axially bulky terphenyl and equatorially bulky dibenzobarrelene groups: synthesis, characterization and olefin polymerization studies
Bo Dong, Qi Yang
DOI: 10.1039/D0PY01152E
The first observation on polymerization of 1,3-benzothiazines: synthesis of mono- and bis-thiazine monomers and thermal properties of their polymers
Seishi Ohashi, Eric Rachita, Sean Baxley, Jessica Zhou, Adam Erlichman, Hatsuo Ishida
DOI: 10.1039/D0PY01521K
One-component rapid Norrish Type II photoinitiation of bulk photo-CuAAC polymer networks
Abhishek U. Shete, Bryan P. Sutherland
DOI: 10.1039/D0PY01310B
Time-dependent covalent network formation in extrudable hydrogels
Dylan Karis, Alshakim Nelson
DOI: 10.1039/D0PY01129K
A covalent organic framework as a photocatalyst for atom transfer radical polymerization under white light irradiation
Xiaoling Fu, Hongjie Yang
DOI: 10.1039/D0PY01545H
Correction: Synthesis and properties of block copolymers composed of norbornene/higher α-olefin gradient segments using ansa-fluorenylamidodimethyltitanium-[Ph3C][B(C6F5)4] catalyst system
Haobo Yuan, Takumitsu Kida, Ryo Tanaka, Zhengguo Cai, Yuushou Nakayama, Takeshi Shiono
DOI: 10.1039/D1PY90010B
Organocatalytic ring-opening polymerization of cyclotrisiloxanes using silanols as initiators for the precise synthesis of asymmetric linear polysiloxanes
Keita Fuchise, Toshiaki Kobayashi, Kazuhiko Sato, Masayasu Igarashi
DOI: 10.1039/D0PY01251C
pH- and chaotropic anion-induced conformational changes of tertiary amine-containing binary heterografted star molecular bottlebrushes in aqueous solution
Ethan W. Kent, Evan M. Lewoczko, Bin Zhao
DOI: 10.1039/D0PY01466D
Biobased thermosensitive polyrotaxanes constructed by polymerization of cyclodextrin-triterpenoid inclusion complexes
Jiawei Li, Xia Yu, Yiran Zhao, Hao Zhang, Jun Hu
DOI: 10.1039/D0PY00966K
こちらもおすすめ
S-(甲硅烷基丙基)異硫酰氯を取り扱う際の実験室安全事項は何ですか?
取り扱う際にはPPE(防護具)が必要です。特に手袋と面マスクは必須です。ドラフトチャンバーを使用して漏洩処理を行い、温度は常温、湿度は乾燥状態、容器はガラス容器...
8-硝基-咪唑并[1,2-a]吡啶とは何ですか?
8-硝基-咪唑并[1,2-a]吡啶は、CAS番号52310-46-0の化合物で、8-位に硝基を有する咪唑並みの结构をもつ吡啶の化合物です。この化合物は、酸化還元...
4-ブロモ-5-メトキシピリジン-2-甲醇の代替品はありますか?
4-ブロモ-5-メトキシピリジン-2-甲醇の代替品には、類似構造を持つ化合物や機能性に等しい代替試薬があります。例えば、4-クロロ-5-メトキシピリジン-2-甲...
全氟-1,2-二甲基環己烷を含む廃棄物はどのように処理すべきですか?
全氟-1,2-二甲基環己烷(CAS番号:306-98-9)の廃棄物は、特別な処理が必要です。まず、廃棄物を密閉容器に収集し、適切な防漏容器に保管します。次に、専...
3-(溴甲基)苯乙酸の主な用途は何ですか?
3-(溴甲基)苯乙酸は主に研究用化学薬品として利用され、有機合成や医薬品の開発に用いられます。また、特定の化合物の合成中間体としても使用されることがあります。
5-イドキド-4-メチオキシ-6-メチルピリミジニン-2-アミンはどのように保存すればよいですか?
5-イドキド-4-メチオキシ-6-メチルピリミジニン-2-アミンは冷暗所で密栓の容器に保存し、直射日光を避けて保管することをお勧めします。温度は常温とし、湿気を...
1-(2-溴-6-甲氧基苯基)乙酮を取り扱う際の実験室安全事項は何ですか?
実験室では、1-(2- Bromo-6-methoxyphenyl)ethanoneを取り扱う際には、ゴーグルや面具、手袋などのPPEを使用することが推奨されま...
5-(4,4,5,5-テトラメチル-1,3,2-ダイオキサボラロール-2-イル)-1,3-ジヒドロ-2-ベンゾフランは安全ですか?
5-(4,4,5,5-テトラメチル-1,3,2-ダイオキサボラロール-2-イル)-1,3-ジヒドロ-2-ベンゾフランは一般に安全ですが、取扱いには注意が必要です...
4-溴萘-1-甲酸の代替品はありますか?
4-溴萘-1-甲酸は比較的稀な化合物ですが、類似物としては、4-クロロ-1-ナフホリック酸やその他のブロモ置換ナフホリック酸が挙げられます。ただし、これらの代替...
ε-白藜芦醇脱氢二聚体の代替品はありますか?
ε-白藜芦醇脱氢二聚体の代替品としては、ε-白藜芦醇、ポリフェノール類、フラボノイド類が挙げられます。これらは類似の化学構造と生物学的活性を持っています。ただし...
掲載誌
Physical Chemistry Chemical Physics

Physical Chemistry Chemical Physics (PCCP) is an international journal co-owned by 19 physical chemistry and physics societies from around the world. This journal publishes original, cutting-edge research in physical chemistry, chemical physics and biophysical chemistry. To be suitable for publication in PCCP, articles must include significant innovation and/or insight into physical chemistry; this is the most important criterion that reviewers and Editors will judge against when evaluating submissions. The journal has a broad scope and welcomes contributions spanning experiment, theory, computation and data science. Topical coverage includes spectroscopy, dynamics, kinetics, statistical mechanics, thermodynamics, electrochemistry, catalysis, surface science, quantum mechanics, quantum computing and machine learning. Interdisciplinary research areas such as polymers and soft matter, materials, nanoscience, energy, surfaces/interfaces, and biophysical chemistry are welcomed if they demonstrate significant innovation and/or insight into physical chemistry. Joined experimental/theoretical studies are particularly appreciated when complementary and based on up-to-date approaches.













![N-[(9H-Fluoren-9-ylmethoxy)carbonyl]serine structure N-[(9H-Fluoren-9-ylmethoxy)carbonyl]serine structure](https://static.chemtradehub.com/structs/737/73724-45-5-b0dc.webp)
![(1S)-1,5-Anhydro-1-[3-(1-benzothiophen-2-ylmethyl)-4-fluorophenyl]-D-glucitol structure (1S)-1,5-Anhydro-1-[3-(1-benzothiophen-2-ylmethyl)-4-fluorophenyl]-D-glucitol structure](https://static.chemtradehub.com/structs/761/761423-87-4-dbeb.webp)