Direct measurement of lipid-soluble arsenic species in biological samples with HPLC-ICPMS
文献情報
Ernst Schmeisser, Walter Goessler, Norbert Kienzl, Kevin A. Francesconi
Lipid-soluble arsenicals (arsenolipids) occur in a wide range of biological samples where they may play a key role in the biosynthesis of organoarsenic compounds from inorganic arsenic. The study of these compounds has been hindered, however, by the lack of a suitable analytical technique able to separate and measure the various lipid species. As a source of arsenolipids, we used 10 crude fish oils from various regions of the world. Total arsenic analyses on the fish oils, performed with ICPMS following acid digestion with microwave-assisted heating, gave concentrations from 4.3 to 10.5 mg As kgā1. All of the arsenic was soluble in non-polar solvents such as hexane. Analysis of the fish oils for arsenolipids was performed by normal phase HPLC-ICPMS with various mixtures of organic solvents as mobile phases. Inherent problems of instability associated with the introduction of organic solvents to the plasma were overcome by the use of reduced column flow, a chilled spray chamber, and the addition of oxygen directly to the plasma. All ten fish oils appeared to contain the same 4ā6 major arsenolipids, but in varying amounts depending on the origin of the fish. Further chromatography with both normal phase and reversed-phase conditions on some of the oils indicated the presence of many more minor arsenolipids. Quantification was achieved by external calibration against triphenylarsine oxide or triphenylarsine sulfide, and the sum of species following HPLC of the oils matched well the total arsenic results (92ā107%). The method was applied to samples of food supplements (fish oil capsules) and a packaged food product (cod liver) whereby arsenolipids were measured and found to be significant arsenic constituents. This study represents the first attempt to directly measure intact arsenolipids and, with appropriate sample preparation, may be suitable for quantitative measurement of these arsenicals in a range of biological samples, including foodstuffs.
関連文献
B800–B850 coherence correlates with energy transfer rates in the LH2 complex of photosynthetic purple bacteria
Cathal Smyth, Daniel G. Oblinsky, Gregory D. Scholes
DOI: 10.1039/C5CP00295H
Enhanced thermal energy harvesting performance of a cobalt redox couple in ionic liquid–solvent mixtures
Manoj A. Lazar, Danah Al-Masri, Douglas R. MacFarlane, Jennifer M. Pringle
DOI: 10.1039/C5CP04305K
CO2 adsorption–desorption performance of mesoporous zirconium hydroxide with robust water durability
Y. Kamimura, A. Endo
DOI: 10.1039/C5CP05211D
The new insight into the structure–activity relation of Pd/CeO2–ZrO2–Nd2O3 catalysts by Raman, in situ DRIFTS and XRD Rietveld analysis
X. Yang, L. Yang, J. Lin, R. Zhou
DOI: 10.1039/C5CP06956D
Theoretical study on the dehydrogenation reaction of dihydrogen bonded phenol–borane-trimethylamine in the excited state
Yonggang Yang, Yufang Liu, Dapeng Yang, Hui Li, Kai Jiang, Jinfeng Sun
DOI: 10.1039/C5CP02530C
Synthesis of branched Pd nanocrystals with tunable structures, their growth mechanism, and enhanced electrocatalytic properties
Xueli Guo, Yiwei Tan
DOI: 10.1039/C5CP05531H
Hydrogen-bonding and vibrational coupling of water in a hydrophobic hydration shell as observed by Raman-MCR and isotopic dilution spectroscopy
Mohammed Ahmed, Ajay K. Singh, Jahur A. Mondal
DOI: 10.1039/C5CP07014G
Micromechanical measurements of the effect of surfactants on cyclopentane hydrate shell properties
Erika P. Brown, Carolyn A. Koh
DOI: 10.1039/C5CP06071K
Electrical conductance and structure of copper atomic junctions in the presence of water molecules
Yu Li, Firuz Demir, Satoshi Kaneko, Shintaro Fujii, Tomoaki Nishino, George Kirczenow, Manabu Kiguchi
DOI: 10.1039/C5CP05227K
Reducing the V2O3(0001) surface through electron bombardment – a quantitative structure determination with I/V-LEED
Felix E. Feiten, Helmut Kuhlenbeck, Hans-Joachim Freund
DOI: 10.1039/C5CP07390A
こちらもおすすめ
S-(甲硅烷基丙基)異硫酰氯を取り扱う際の実験室安全事項は何ですか?
取り扱う際にはPPE(防護具)が必要です。特に手袋と面マスクは必須です。ドラフトチャンバーを使用して漏洩処理を行い、温度は常温、湿度は乾燥状態、容器はガラス容器...
8-硝基-咪唑并[1,2-a]吡啶とは何ですか?
8-硝基-咪唑并[1,2-a]吡啶は、CAS番号52310-46-0の化合物で、8-位に硝基を有する咪唑並みの结构をもつ吡啶の化合物です。この化合物は、酸化還元...
4-ブロモ-5-メトキシピリジン-2-甲醇の代替品はありますか?
4-ブロモ-5-メトキシピリジン-2-甲醇の代替品には、類似構造を持つ化合物や機能性に等しい代替試薬があります。例えば、4-クロロ-5-メトキシピリジン-2-甲...
全氟-1,2-二甲基環己烷を含む廃棄物はどのように処理すべきですか?
全氟-1,2-二甲基環己烷(CAS番号:306-98-9)の廃棄物は、特別な処理が必要です。まず、廃棄物を密閉容器に収集し、適切な防漏容器に保管します。次に、専...
3-(溴甲基)苯乙酸の主な用途は何ですか?
3-(溴甲基)苯乙酸は主に研究用化学薬品として利用され、有機合成や医薬品の開発に用いられます。また、特定の化合物の合成中間体としても使用されることがあります。
5-イドキド-4-メチオキシ-6-メチルピリミジニン-2-アミンはどのように保存すればよいですか?
5-イドキド-4-メチオキシ-6-メチルピリミジニン-2-アミンは冷暗所で密栓の容器に保存し、直射日光を避けて保管することをお勧めします。温度は常温とし、湿気を...
1-(2-溴-6-甲氧基苯基)乙酮を取り扱う際の実験室安全事項は何ですか?
実験室では、1-(2- Bromo-6-methoxyphenyl)ethanoneを取り扱う際には、ゴーグルや面具、手袋などのPPEを使用することが推奨されま...
5-(4,4,5,5-テトラメチル-1,3,2-ダイオキサボラロール-2-イル)-1,3-ジヒドロ-2-ベンゾフランは安全ですか?
5-(4,4,5,5-テトラメチル-1,3,2-ダイオキサボラロール-2-イル)-1,3-ジヒドロ-2-ベンゾフランは一般に安全ですが、取扱いには注意が必要です...
4-溴萘-1-甲酸の代替品はありますか?
4-溴萘-1-甲酸は比較的稀な化合物ですが、類似物としては、4-クロロ-1-ナフホリック酸やその他のブロモ置換ナフホリック酸が挙げられます。ただし、これらの代替...
ε-白藜芦醇脱氢二聚体の代替品はありますか?
ε-白藜芦醇脱氢二聚体の代替品としては、ε-白藜芦醇、ポリフェノール類、フラボノイド類が挙げられます。これらは類似の化学構造と生物学的活性を持っています。ただし...
掲載誌
Analyst

Analyst publishes analytical and bioanalytical research that reports premier fundamental discoveries and inventions, and the applications of those discoveries, unconfined by traditional discipline barriers.














![Sodium (2Z)-7-{[(2R)-2-amino-2-carboxyethyl]sulfanyl}-2-({[(1S)-2,2-dimethylcyclopropyl]carbonyl}amino)-2-heptenoate structure Sodium (2Z)-7-{[(2R)-2-amino-2-carboxyethyl]sulfanyl}-2-({[(1S)-2,2-dimethylcyclopropyl]carbonyl}amino)-2-heptenoate structure](https://static.chemtradehub.com/structs/811/81129-83-1-441c.webp)