Determination of extractable perfluorooctanoic acid (PFOA) in water, sweat simulant, saliva simulant, and methanol from textile and carpet samples by LC/MS/MS
文献情報
Michael P. Mawn, Richard G. McKay, Timothy W. Ryan, Bogdan Szostek, Charles R. Powley, Robert C. Buck
Methods were developed to quantify the amount of perfluorooctanoic acid (PFOA) extracted from textile and carpet samples through contact with water, methanol, and sweat and saliva simulants using LC/MS/MS. The limit of quantitation (LOQ) for samples extracted in water and sweat simulant is 1 ppb (ng PFOA (g sample)−1) while the limits of quantitation for samples extracted in saliva simulant and methanol were 3 ppb and 2.5 ppb, respectively. Method validation results are provided for a polyester control textile sample that was extracted in water on two different days by different analysts, which gave an overall recovery of 103% and standard deviation of 5.3% for 30 analyses. However, for routine application of these methods to a large number of sample sets differing in chemical and physical compositions, a complete validation for each sample type is not practical or possible since control samples for fortifications are often not available. Instead, suitable analytical methods and acceptance criteria are described which ensure accurate PFOA quantitation in each of the solvent extract types. During routine use of these methods, post-extraction spike recoveries for the different sample types and solvents are 100 ± 15% using a dual isotopically labeled 13C-PFOA internal standard to correct for matrix effects. A comparison of extraction solvent versus time using a wrist action shaker for textile and carpet samples demonstrates that the total extractable amount of PFOA is similar for each of the solvent types. However, as expected the rate of extraction in water and simulants is significantly less than that of methanol. Finally, a comparison of 2 h and 24 h wrist action shaker extractions with a 1.5 h pressurized fluid extraction (PFE) in methanol reveals that the 24 h wrist action shaker yields the highest results. The 2 h wrist action shaker results are similar to those of the 1.5 h PFE extraction.
関連文献
Comment on “Two-dimensional penta-like PdPSe with a puckered pentagonal structure: a first-principles study” by A. Bafekry, M. M. Fadlallah, M. Faraji, A. Shafique, H. R. Jappor, I. Abdolhoseini Sarsari, Y. S. Ang and M. Ghergherehchii, Phys. Chem. Chem. Phys., 2022, 24, 9990
Suman Chowdhury, Fazel Shojaei, Bohayra Mortazavi
DOI: 10.1039/D2CP01587K
Quantum mechanical studies of p-azoxyanisole and identification of its electro-optic activity
Manish Kumar, Mirtunjai Mishra, Devendra Singh
DOI: 10.1039/D3CP00084B
Modified BET theory for actual surfaces: implementation of surface curvature
Behnaz Alinaghipour, Cavus Falamaki
DOI: 10.1039/D2CP05575A
Tuning of the electronic and photocatalytic properties of Janus WSiGeZ4 (Z = N, P, and As) monolayers via strain engineering
Ming-Yang Liu, Yao He, Xuan Li, Kai Xiong
DOI: 10.1039/D2CP05224E
Reduction of transient carnosine radicals depends on β-alanyl amino group charge
Olga B. Morozova, Alexandra V. Yurkovskaya
DOI: 10.1039/D2CP04933C
Towards structural reconstruction from X-ray spectra
Anton Vladyka, Christoph J. Sahle, Johannes Niskanen
DOI: 10.1039/D2CP05420E
Jahn–Teller effects in initial and final states: high-resolution X-ray absorption, photoelectron and Auger spectroscopy of allene
Eva Muchova, Daniel Hollas, David M. P. Holland, Camila Bacellar, Ludmila Leroy, Thomas R. Barillot, Luca Longetti, Marcello Coreno, Monica de Simone, Cesare Grazioli, Majed Chergui, Rebecca A. Ingle
DOI: 10.1039/D2CP05299G
Insight into the structural and electrochemical properties of the interface between a Na6SOI2 solid electrolyte and a metallic Na anode
Song-Hyok Choe, Won-Hyok Hong, Kum-Chol Kim, Chol-Jun Yu
DOI: 10.1039/D2CP05290C
こちらもおすすめ
S-(甲硅烷基丙基)異硫酰氯を取り扱う際の実験室安全事項は何ですか?
取り扱う際にはPPE(防護具)が必要です。特に手袋と面マスクは必須です。ドラフトチャンバーを使用して漏洩処理を行い、温度は常温、湿度は乾燥状態、容器はガラス容器...
8-硝基-咪唑并[1,2-a]吡啶とは何ですか?
8-硝基-咪唑并[1,2-a]吡啶は、CAS番号52310-46-0の化合物で、8-位に硝基を有する咪唑並みの结构をもつ吡啶の化合物です。この化合物は、酸化還元...
4-ブロモ-5-メトキシピリジン-2-甲醇の代替品はありますか?
4-ブロモ-5-メトキシピリジン-2-甲醇の代替品には、類似構造を持つ化合物や機能性に等しい代替試薬があります。例えば、4-クロロ-5-メトキシピリジン-2-甲...
全氟-1,2-二甲基環己烷を含む廃棄物はどのように処理すべきですか?
全氟-1,2-二甲基環己烷(CAS番号:306-98-9)の廃棄物は、特別な処理が必要です。まず、廃棄物を密閉容器に収集し、適切な防漏容器に保管します。次に、専...
3-(溴甲基)苯乙酸の主な用途は何ですか?
3-(溴甲基)苯乙酸は主に研究用化学薬品として利用され、有機合成や医薬品の開発に用いられます。また、特定の化合物の合成中間体としても使用されることがあります。
5-イドキド-4-メチオキシ-6-メチルピリミジニン-2-アミンはどのように保存すればよいですか?
5-イドキド-4-メチオキシ-6-メチルピリミジニン-2-アミンは冷暗所で密栓の容器に保存し、直射日光を避けて保管することをお勧めします。温度は常温とし、湿気を...
1-(2-溴-6-甲氧基苯基)乙酮を取り扱う際の実験室安全事項は何ですか?
実験室では、1-(2- Bromo-6-methoxyphenyl)ethanoneを取り扱う際には、ゴーグルや面具、手袋などのPPEを使用することが推奨されま...
5-(4,4,5,5-テトラメチル-1,3,2-ダイオキサボラロール-2-イル)-1,3-ジヒドロ-2-ベンゾフランは安全ですか?
5-(4,4,5,5-テトラメチル-1,3,2-ダイオキサボラロール-2-イル)-1,3-ジヒドロ-2-ベンゾフランは一般に安全ですが、取扱いには注意が必要です...
4-溴萘-1-甲酸の代替品はありますか?
4-溴萘-1-甲酸は比較的稀な化合物ですが、類似物としては、4-クロロ-1-ナフホリック酸やその他のブロモ置換ナフホリック酸が挙げられます。ただし、これらの代替...
ε-白藜芦醇脱氢二聚体の代替品はありますか?
ε-白藜芦醇脱氢二聚体の代替品としては、ε-白藜芦醇、ポリフェノール類、フラボノイド類が挙げられます。これらは類似の化学構造と生物学的活性を持っています。ただし...
掲載誌
Analyst

Analyst publishes analytical and bioanalytical research that reports premier fundamental discoveries and inventions, and the applications of those discoveries, unconfined by traditional discipline barriers.











![(1S)-1,5-Anhydro-1-[3-(1-benzothiophen-2-ylmethyl)-4-fluorophenyl]-D-glucitol structure (1S)-1,5-Anhydro-1-[3-(1-benzothiophen-2-ylmethyl)-4-fluorophenyl]-D-glucitol structure](https://static.chemtradehub.com/structs/761/761423-87-4-dbeb.webp)


![Sodium (2Z)-7-{[(2R)-2-amino-2-carboxyethyl]sulfanyl}-2-({[(1S)-2,2-dimethylcyclopropyl]carbonyl}amino)-2-heptenoate structure Sodium (2Z)-7-{[(2R)-2-amino-2-carboxyethyl]sulfanyl}-2-({[(1S)-2,2-dimethylcyclopropyl]carbonyl}amino)-2-heptenoate structure](https://static.chemtradehub.com/structs/811/81129-83-1-441c.webp)