Differences in the internal energies of ions in electrospray ionization mass spectrometers equipped with capillary–skimmer and capillary–RF lens interfaces

文献情報

出版日 2023-10-03
DOI 10.1039/D3AY01450A
インパクトファクター 2.896
著者

Daiki Asakawa, Ryoma Yamamoto, Nobuyasu Hanari, Kazumi Saikusa


原文を見る

要旨

Small metabolites are commonly analyzed using electrospray ionization mass spectrometry (ESI-MS). Although the protonated form of a compound of interest is typically the target ion in ESI-MS, the protonated forms of small metabolites occasionally undergo fragmentation during ion transmission from ambient conditions to vacuum conditions, hindering the unambiguous identification of analyte molecules. To estimate the fragmentation efficiency during ESI processes, the internal energy distribution of the ions (P(E)) must be evaluated. The common approach for the P(E) evaluation is the survival yield method, which uses thermometer ions. In this study, the P(E) of ions produced by an ESI source in a commercial triple quadrupole mass spectrometer equipped with a capillary–skimmer and capillary–RF lens interfaces was evaluated using benzyl ammonium thermometer ions. Furthermore, this study proposes the use of 3-(aminomethyl)indole and related compounds, which have the lowest Eapp values among the reported thermometer ions, to obtain P(E) values of the ions more accurately. Results showed that P(E) strongly depends on whether a capillary–skimmer interface or capillary–RF lens interface was used for ion transport to the vacuum. ESI-MS with a capillary–skimmer interface provided a considerably lower and narrower P(E) of ions than that with a capillary–RF lens interface, thereby producing intact protonated molecules without significant fragmentation of most small metabolites. However, ESI-MS equipped with capillary–RF lens interfaces provided a higher efficiency of ion transmission than ESI-MS equipped with a capillary–skimmer interface, allowing for highly sensitive analysis of metabolites.

関連文献

An “active” and self-switchable nanoreactor

Bo Peng, Xinhua Yuan, Maiyong Zhu, Songjun Li

2013-08-30 Paper

DOI: 10.1039/C3PY01074K

Preparation of a D–A polymer with disilanobithiophene as a new donor component and application to high-voltage bulk heterojunction polymer solar cells

Joji Ohshita, Makoto Nakashima, Daiki Tanaka, Yasushi Morihara, Hiroyuki Fueno, Kazuyoshi Tanaka

2013-10-17 Communication

DOI: 10.1039/C3PY01157G

The use of a carbon paste electrode mixed with multiwalled carbon nanotube/electroactive polyimide composites as an electrode for sensing ascorbic acid

Tsao-Cheng Huang, Lu-Chen Yeh, Hsiu-Ying Huang, Zheng-Yong Nian, Yi-Chun Yeh, Yi-Chen Chou, Jui-Ming Yeh, Mei-Hui Tsai

2013-09-05 Paper

DOI: 10.1039/C3PY00787A

Precise evaluation of the block copolymer nanoparticle growth in polymerization-induced self-assembly under dispersion conditions

Yang Su, Xin Xiao, Shentong Li, Meihan Dan, Xiaohui Wang, Wangqing Zhang

2013-08-30 Paper

DOI: 10.1039/C3PY00995E

Synthesis of novel trithiocarbonate and allyl sulfide containing monomers

Christopher R. Fenoli

2013-08-14 Paper

DOI: 10.1039/C3PY00709J

Binding and supramolecular organization of homo- and heterotelechelic oligomers in solutions

Jessalyn Cortese, Corinne Soulié-Ziakovic, Ludwik Leibler

2013-07-19 Paper

DOI: 10.1039/C3PY00638G

Polymerization-Induced Self-Assembly (PISA) – control over the morphology of nanoparticles for drug delivery applications

Bunyamin Karagoz, Hien T. Duong, Johan S. Basuki, Cyrille Boyer

2013-10-22 Communication

DOI: 10.1039/C3PY01306E

Micellar-cluster association of ureidopyrimidone functionalized monochelic polybutadiene

Sachin Laxman Bobade, Thomas Malmgren

2013-09-09 Paper

DOI: 10.1039/C3PY01002C

Polyacetylenes containing BODIPY pendants with different connectivities: synthesis, characterization and opto-electronic properties

Bin Liu, Lingfeng Li, Cuiling Lin, Jingdan Zhou, Zhexin Zhu, Hongyao Xu, Huayu Qiu, Shouchun Yin

2013-09-11 Paper

DOI: 10.1039/C3PY01021J

こちらもおすすめ

化合物よくある質問

除水剤ALT-201は安全ですか?

除水剤ALT-201は一般的に安全ですが、避けるべきは皮膚や目への接触です。適切な防護具を着用し、安全基準を守ることが重要です。

28770-01-62-(2-Isopropyl-1,3-o...
化合物よくある質問

「邻羟基阿托伐他汀内酯标准品」に適用される法規ガイドelinesは何ですか?

CAS番号163217-74-1の「邻羟基阿托伐他汀内酯标准品」は、GHS分類では危険物に分類されず、主にREACH規則とFDA/EPAの管理対象となります。R...

163217-74-1ortho-Hydroxy Atorva...
化合物よくある質問

メチル(3R)-3-アミノ-2,3-ジヒドロ-1-ベンゾファンラニン-5-カルボイル酸塩塩酸塩の主な用途は何ですか?

メチル(3R)-3-アミノ-2,3-ジヒドロ-1-ベンゾファンラニン-5-カルボイル酸塩塩酸塩は、医薬品や合成化学の研究に広く用いられます。また、特定の薬物の前...

2241594-15-8Methyl (3R)-3-amino-...
化合物よくある質問

トランス-4-メチルピロリジン-3-オール塩酸塩はどのように合成されますか?

トランス-4-メチルピロリジン-3-オール塩酸塩は、4-メチルピロリジンの塩酸塩化によって合成されます。一般的な合成方法では、4-メチルピロリジンを塩酸に加えて...

265108-42-7trans-4-Methylpyrrol...
化合物よくある質問

硫雜環丁烷-1,1-二氧化物は安全ですか?

硫雜環丁烷-1,1-二氧化物は安全ではありません。毒性は報告されていませんが、高温下で分解し、可燃性があるため、高圧ガスは注意が必要です。密閉した容器で保管し、...

5687-92-3Thietane 1,1-dioxide
化合物よくある質問

ブラエリリンの主な用途は何ですか?

ブラエリリンは主に医薬品製造における薬物アドベリンの合成材料として使用されます。また、研究用途や化学合成材料としても広く利用されています。

6054-10-02H, 8H-Benzo[1,2-b
化合物よくある質問

9-ヒドロキシエリプチシネ塩酸塩はどのように合成されますか?

9-ヒドロキシエリプチシネ塩酸塩は、エリプチシネから塩酸を添加することで合成されます。選択性は高いですが、収率は約70%です。

52238-35-49-Hydroxyellipticine...
化合物よくある質問

5-塩素-2-(メチルアミノ)フェニル-(2-塩素フェニル)メタン酮の物理化学的性質は何ですか?

5-塩素-2-(メチルアミノ)フェニル-(2-塩素フェニル)メタン酮のCAS番号は5621-86-3です。この化合物は白色の結晶性粉末で、分子量は415.03で...

5621-86-3[5-Chloro-2-(methyla...
化合物よくある質問

1-[2-(4-甲氧基-苯氧基)-乙基]-哌嗪はどのように保存すればよいですか?

1-[2-(4-甲氧基-苯氧基)-乙基]-哌嗪は、直射日光を避けて暗所に、室温(15-25℃)で保管し、密閉容器に入れることで安定性を保つことができます。

117132-44-21-[2-(4-Methoxy-phen...
化合物よくある質問

2-[3-(4-甲氧基フェニル)プロピル]-4,4,5,5-四メチル-1,3,2-ドイボロロールアンの主な用途は何ですか?

2-[3-(4-甲氧基フェニル)プロピル]-4,4,5,5-四メチル-1,3,2-ドイボロロールアンは、医薬品の合成、有機合成化学、および新材料の研究で使用され...

1073371-72-82-[3-(4-Methoxypheny...

掲載誌

Analytical Methods

Analytical Methods
CiteScore: 5.1
自己引用率: 3.7%
年間論文数: 655

Analytical Methods welcomes early applications of new analytical and bioanalytical methods and technology demonstrating the potential for societal impact. We require that methods and technology reported in the journal are sufficiently innovative, robust, accurate, and compared to other available methods for the intended application. Developments with interdisciplinary approaches are particularly welcome. Systems should be proven with suitably complex and analytically challenging samples. We encourage developments within, but not limited to, the following technologies and applications: global health, point-of-care and molecular diagnostics biosensors and bioengineering drug development and pharmaceutical analysis applied microfluidics and nanotechnology omics studies, such as proteomics, metabolomics or glycomics environmental, agricultural and food science neuroscience biochemical and clinical analysis forensic analysis industrial process and method development

おすすめサプライヤー

免責事項
このページに表示される学術雑誌情報は、参考および研究目的のみを目的としています。当社は雑誌出版社とは提携しておらず、投稿の取り扱いも行っておりません。出版に関するお問い合わせは、各雑誌出版社に直接ご連絡ください。
表示されている情報に誤りがある場合は、support@chemtradehub.com までご連絡ください。迅速に確認し、対応いたします。