Unusual thermal phase transition behavior of an ionic liquid and poly(ionic liquid) in water with significantly different LCST and dynamic mechanism
文献情報
Wenlong Li, Peiyi Wu
Dynamic thermal phase transition behavior of a well-defined thermoresponsive ionic liquid (IL), [P4,4,4,4][SS], and its polymer, poly(ionic liquid) (PIL), P[P4,4,4,4][SS], synthesized by modified free radical polymerization was investigated by means of DSC, turbidity, temperature-variable 1H NMR, FT-IR spectroscopy measurements, in combination with perturbation correlation moving window (PCMW) and two-dimensional correlation (2Dcos) analysis. Obvious distinction was observed between the LCST of monomer and polymer solutions indicating their largely different dynamic transition process. Further studies revealed that the aggregation of [P4,4,4,4][SS] is mainly driven by the synergetic variations of cations and anions while the separation process of the P[P4,4,4,4][SS] solution is found to be dominated by conformation changes of anions. Finally, 2Dcos was employed to elucidate the sequence order of chemical group motion during heating. It is concluded that synergetic variations of cations and anions in the [P4,4,4,4][SS] solution resulted in the randomly aggregated structure of globules during separation. In contrast, in the P[P4,4,4,4][SS] solution, anions of repeated units tend to be wrapped into the aggregated globules while cations would distribute at the periphery of globules after transition. Additionally, several unusual phenomena were also interpreted, such as the different varying tendency in LCST of monomer and polymer solutions with increasing concentration, their distinction in the final transmittance and their rather different LCST at the same concentration.
おすすめジャーナル

Chemical Communications

Russian Journal of Bioorganic Chemistry

Russian Journal of General Chemistry

Saudi Pharmaceutical Journal

Journal of Peptide Science

Journal of Natural Medicines

Current Opinion in Solid State & Materials Science

Nature Medicine

Crystallography Reports

Journal of Saudi Chemical Society
関連文献
Systematic modification of the indium tin oxide work function via side-chain modulation of an amino-acid functionalization layer
Naomi Kramer, Soumyajit Sarkar, Leeor Kronik, Nurit Ashkenasy
DOI: 10.1039/C9CP04079J
Mechanochemical reaction of Al and melamine: a potential approach towards the in situ synthesis of aluminum nitride–carbon nanotube nanocomposites
Seyyed Amin Rounaghi, Hossein Eshghi, Sergio Scudino, Elaheh Esmaeili, Ali-Reza Kiani-Rashid
DOI: 10.1039/C9CP04577E
Understanding the selectivity of inhibitors toward PI4KIIIα and PI4KIIIβ based molecular modeling
Shuaizhen Tian, Jinzhe Zeng, Xiao Liu, Jianzhong Chen
DOI: 10.1039/C9CP03598B
Metallic FeSe monolayer as an anode material for Li and non-Li ion batteries: a DFT study
Xiaodong Lv, Fengyu Li, Jian Gong, Jinxing Gu, Shiru Lin, Zhongfang Chen
DOI: 10.1039/D0CP00967A
Synergistic effect of supercritical CO2 and organic solvent on exfoliation of graphene: experiment and atomistic simulation studies
Lixi Liu, Yan Chen, Fei Dang, Yilun Liu, Xiaogeng Tian
DOI: 10.1039/C9CP03654G
Unveiling the efficiency of microwave-assisted hydrothermal treatment for the preparation of SrTiO3 mesocrystals
Luís F. da Silva, Ariadne C. Catto, Waldir Avansi, Jr, Alexandre Mesquita, Lauro J. Q. Maia, Osmando F. Lopes, Máximo Siu Li, Mário L. Moreira, Elson Longo, Juan Andrés, Valmor R. Mastelaro
DOI: 10.1039/C9CP02893E
Revealing the thermodynamics of individual catalytic steps based on temperature-dependent single-particle nanocatalysis
Tao Chen
DOI: 10.1039/C9CP04538D
Structure, electrical conductivity and oxygen transport properties of perovskite-type oxides CaMn1−x−yTixFeyO3−δ
Rian Ruhl, Jia Song, Vincent Thoréton, Sathya Prakash Singh, Kjell Wiik, Yngve Larring, Henny J. M. Bouwmeester
DOI: 10.1039/C9CP04911H
Ferroelectricity and multiferroicity in two-dimensional Sc2P2Se6 and ScCrP2Se6 monolayers
Xukun Feng, Jian Liu, Xikui Ma, Mingwen Zhao
DOI: 10.1039/C9CP06966F
こちらもおすすめ
「邻羟基阿托伐他汀内酯标准品」に適用される法規ガイドelinesは何ですか?
CAS番号163217-74-1の「邻羟基阿托伐他汀内酯标准品」は、GHS分類では危険物に分類されず、主にREACH規則とFDA/EPAの管理対象となります。R...
メチル(3R)-3-アミノ-2,3-ジヒドロ-1-ベンゾファンラニン-5-カルボイル酸塩塩酸塩の主な用途は何ですか?
メチル(3R)-3-アミノ-2,3-ジヒドロ-1-ベンゾファンラニン-5-カルボイル酸塩塩酸塩は、医薬品や合成化学の研究に広く用いられます。また、特定の薬物の前...
トランス-4-メチルピロリジン-3-オール塩酸塩はどのように合成されますか?
トランス-4-メチルピロリジン-3-オール塩酸塩は、4-メチルピロリジンの塩酸塩化によって合成されます。一般的な合成方法では、4-メチルピロリジンを塩酸に加えて...
硫雜環丁烷-1,1-二氧化物は安全ですか?
硫雜環丁烷-1,1-二氧化物は安全ではありません。毒性は報告されていませんが、高温下で分解し、可燃性があるため、高圧ガスは注意が必要です。密閉した容器で保管し、...
9-ヒドロキシエリプチシネ塩酸塩はどのように合成されますか?
9-ヒドロキシエリプチシネ塩酸塩は、エリプチシネから塩酸を添加することで合成されます。選択性は高いですが、収率は約70%です。
5-塩素-2-(メチルアミノ)フェニル-(2-塩素フェニル)メタン酮の物理化学的性質は何ですか?
5-塩素-2-(メチルアミノ)フェニル-(2-塩素フェニル)メタン酮のCAS番号は5621-86-3です。この化合物は白色の結晶性粉末で、分子量は415.03で...
1-[2-(4-甲氧基-苯氧基)-乙基]-哌嗪はどのように保存すればよいですか?
1-[2-(4-甲氧基-苯氧基)-乙基]-哌嗪は、直射日光を避けて暗所に、室温(15-25℃)で保管し、密閉容器に入れることで安定性を保つことができます。
2-[3-(4-甲氧基フェニル)プロピル]-4,4,5,5-四メチル-1,3,2-ドイボロロールアンの主な用途は何ですか?
2-[3-(4-甲氧基フェニル)プロピル]-4,4,5,5-四メチル-1,3,2-ドイボロロールアンは、医薬品の合成、有機合成化学、および新材料の研究で使用され...
掲載誌
Polymer Chemistry

Polymer Chemistry welcomes submissions in all areas of polymer science that have a strong focus on macromolecular chemistry. Manuscripts may cover a broad range of fields, yet no direct application focus is required.

![S-[2,3-Bis(palmitoyloxy)propyl]-N-[(9H-fluoren-9-ylmethoxy)(hydroxy)methylene]cysteine structure S-[2,3-Bis(palmitoyloxy)propyl]-N-[(9H-fluoren-9-ylmethoxy)(hydroxy)methylene]cysteine structure](https://static.chemtradehub.com/structs/210/210532-98-2-f6a7.webp)


phosphoryl}methyl 4-methylbenzenesulfonate structure {[3-(Hexadecyloxy)propoxy](hydroxy)phosphoryl}methyl 4-methylbenzenesulfonate structure](https://static.chemtradehub.com/structs/864/864068-45-1-ba7c.webp)